Repeating Sequence (Simulink Reference)

Generate an arbitrarily shaped periodic signal

Library

Sources

Description

The Repeating Sequence block outputs a periodic scalar signal having a waveform that you specify. You can specify any waveform, using the block dialog's Time values and Output values parameters. The Times value parameter specifies a vector of sample times. The Output values parameter specifies a vector of signal amplitudes at the corresponding sample times. Together, the two parameters specify a sampling of the output waveform at points measured from the beginning of the interval over which the waveform repeats (i.e., the signal's period). For example, by default, the Time values and Output values parameters are both set to [0 2]. This default setting specifies a sawtooth waveform that repeats every 2 seconds from the start of the simulation and has a maximum amplitude of 2. The Repeating Sequence block uses linear interpolation to compute the value of the waveform between the specified sample points.

Data Type Support

The Repeating Sequence block outputs real signals of type double.

Parameters and Dialog Box

Opening this dialog box causes a running simulation to pause. See Changing Source Block Parameters in the online Simulink documentation for details.

Time values: A vector of monotonically increasing time values. The default is [0 2].
Output values: A vector of output values. Each corresponds to the time value in the same column. The default is [0 2].

Characteristics

Sample Time
Continuous

Scalar Expansion
No

Dimensionalized
No

Zero Crossing
No

Sample Time	Continuous
Scalar Expansion	No
Dimensionalized	No
Zero Crossing	No

Relay Repeating Sequence Interpolated