| Using Simulink | |
The Configuration Parameters Dialog Box
The Configuration Parameters dialog box allows you to modify settings for a model's active configuration set (see Configuration Sets).
| Note You can also use the Model Explorer to modify settings for the active configuration set as well as for any other configuration set. See The Model Explorer for more information. |
To display the dialog box, select Configuration Parameters from the model editor's Simulation or context menu. The dialog box appears.
The dialog box groups the controls used to set the configuration parameters into various categories. To display the controls for a specific category, click the category in the Select tree on the left side of the dialog box. See the following sections for information on how to use the various categories of controls to set configuration parameters for the active configuration set.
In most cases, Simulink does not immediately apply a change that you have made with a control. To apply a change, you must click either the OK or the Apply button at the bottom of the dialog box. The OK button applies all the changes you made and dismisses the dialog box. The Apply button applies the changes but leaves the dialog box open so that you can continue to make changes.
Note
Each of the controls on the Configuration Parameters dialog box correspond to a configuration parameter that you can set via the sim and simset commands. The "Model Parameters" subsection of the "Model and Block Parameters" section of the Simulink Reference documentation lists these parameters. This section also specifies for each configuration parameter the Configuration Parameters dialog box prompt of the control that sets it. This allows you to determine the model parameter corresponding to a control on the Configuration Parameters dialog box.
|
| | The Model Configuration Preferences Dialog Box | The Solver Pane | |
© 1994-2005 The MathWorks, Inc.
